Spray on as well as wipe off, the Reflow Oven Cleaner assaults charred, baked-on change residues that build up on reflow stoves. It likewise cleanses pallets, conveyors, flux condensers, frustrates, heating elements, clamps, chains, pulley-blocks, equipments and also real estates. This unique cleaner uses the latent heat created by ovens and also associated tools to speed up the cleaning of these important systems to boost productivity as well as lower expenses.
Melts away burned-on flux deposits from wave solder equipments & reflow stoves.
Functions as much as four times faster than isopropanol.
Rapid, safe cleaning of pallets, frustrates, burner, clamps, chains, drive equipments & housings
Aggressive cleanser with minimum smell
Triggered by the heat of the stove
Can be utilized in dip tanks as well as ultrasonic cleansers
Reflow Oven Cleaner can promptly set up high-density PCBs that might posture manual hand soldering challenges to even the most knowledgeable engineers as well as PCB specialists. To start, a solder paste blend consisting of both solder and also flux is applied with a stencil to the fabricated PCB. The parts are positioned ready and also are usually kept in place by the sticky nature of the solder paste. Lastly, the PCB is placed inside the reflow oven to begin the heating process.
The Reflow Oven Cleaner process is based upon convection heating, similar to that in your house stove. The temperature level of the hot air in the oven adheres to a thermal account that gives the optimal warm as well as air conditioning price for the given solder paste and also elements. Electronics makers offer suggested thermal profiles that act as a good starting factor. However sometimes the thermal account must be modified for the best Reflow Oven Cleaner performance.
The Reflow Phase
After the thermal soak, the procedure reaches the reflow phase. At this point, the oven’s temperature rises above the solder paste’s melting point. The temperature triggers the paste to melt and develop a liquid. This fluid will end up being the circuit board’s solder joints. The process functions by the flux in the solder. It decreases surface tension at the joints as well as creates metallurgic bonding.
Throughout the Reflow Oven Cleaner phase, it is essential to make certain the maximum temperature level. This will supply effective and also top notch soldering. It is likewise required to see to it that the reflow time is right. Not enough warm will cause inadequate joints. Excessive warm can lead to harm to the circuit board as well as its parts.
The time spent in the Reflow Oven Cleaner is typically in between 30-60 seconds. Again, it is important to not have too brief or also long a reflow time. Too short and the solder may not reach over its melting point long enough to form reliable joints. As well as long as well as the joints might become brittle.